What would cause this? - Bambu Lab X1-Carbon - Bambu Lab Community Forum

The original hot end ended up getting bent (don’t know how, but it did). I replaced it with the included replacement. I did a calibration and everything looked fine. I went to print a simple model on extra fine 0.08mm on the BBL textured PEI plate (as see in the pic) with Overture PETG. As you can see, the nozzle tip gouged the plate and broke off and ended up bending the hot end. What would have caused this to happen? Did I miss a step in the installation of the replacement hot end? Is t

Bambu Studio Beta - FW update not prompted for X1C · Issue #2000

A Variety of Observations and Complaints - Bambu Lab X1 Series

My V2 and Bamboo lab X1 Carbon

Bambu Lab X1 Carbon with AMS Review - 3DGearZone

3D Printer Review: Bambu A1 Mini with AMS - Make

Bambu Lab 3D

Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics

My V2 and Bamboo lab X1 Carbon

Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum

Bambu Labs X1 Carbon