PA tuning Duet3D Forum

.6mm nozzle, PETG retraction - 0.1mm coasting - 0mm PA - 0.03 cube looks great but cylinder .. these holes allign with retraction s3d config ; processName,Process1 ; applyToModels,Locking_tool_v2,Inner_Ring_v2,Outer_Ring_v1 ; profileName,E5-1-PETG 0

Issues with pressure advance since RRF 3.4

which Input shaping

Issues with pressure advance since RRF 3.4

Input Shaping + Pressure Advance Artifact

Pressure advance tuning with conditional G-code

Pressure advance tuning. micro swiss ng : r/klippers

Underextrusion at the end of first layer

Technology XYZ dims *

Temperatures totally wrong 3.4 RC

Currents E3D Online 3D Printing Forum

Blog, XYZ dims *

Tuning input shaping and PA 3.5b3

RepRap Firmware On Sidewinder X1: SKR 1.3/1.4

RepRap Firmware On Sidewinder X1: SKR 1.3/1.4

Install Klipper on ANY 3d printer - Part 1 - Intro and the Basics