How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum

I have an fill layer I am trying to reverse I know i can put a box around it and get this Which does put most of the fill where i want it but it does not follow the cut outs of the original edges and it also has a ton of fill that is just a complete waste of time. Is there a way to get the fill i want to follow the edges with the tabs and not have so much fill where its not needed. Here is the file UR_Box.lbrn2 (597.5 KB)

Invert Engrave or Fill - LightBurn Software Questions - LightBurn Software Forum

How to fill inside the vector lines - LightBurn Software Questions - LightBurn Software Forum

Fill & Line is NOT gone from Lightburn Laser Software!

Invert Engrave or Fill - LightBurn Software Questions - LightBurn Software Forum

Filling outside the lines - LightBurn Software Questions - LightBurn Software Forum

Filling too much - LightBurn Software Questions - LightBurn Software Forum

Trace tool is inverting the image - LightBurn Software Questions - LightBurn Software Forum

Issues with fill - LightBurn Software Questions - LightBurn Software Forum

How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum

Convert to Path is grayed out - LightBurn Software Questions - LightBurn Software Forum

Line and Fill problem - LightBurn Software Questions - LightBurn Software Forum